• Joe@discuss.tchncs.de
    link
    fedilink
    English
    arrow-up
    10
    ·
    3 hours ago

    Interesting fact: You can use an elephant’s trunk as a low-resolution 3D printing nozzle

    • dellish@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      3 hours ago

      Yes but does it have to be dead at the time?

      I’m really not sure why they felt the need to point this out in the article.

      • crapwittyname@feddit.uk
        link
        fedilink
        English
        arrow-up
        3
        ·
        43 minutes ago

        Yes, the first attempts via the more obvious approach of using a live mosquito were a lot trickier, because the techniques required in persuading the mosquito to comply were outside of the specialist knowledge base of the team. That is, until one serendipitous moment when a heavy-handed researcher accidentally killed a mosquito whilst trying to attach it to a printer. The surprise and elation that must have resulted when they realised they could use mosquito husks must have been a sight to behold. The missing piece of the puzzle had finally fallen into place; some might say by Divine Providence. I daresay some of the project leads were kicking themselves! “It’s so simple! Dead mosquito proboscises! Dead! Why didn’t I think of that?!”, etc. But I think we should go easy on those people, we could all get a doctorate in the field of hindsight!
        In the end, just like many discoveries before, penicillin, safety glasses, velcro etc., this breakthrough owes a lot to blind chance.