The switches don’t have to control the lights they are wired to. I have Inovelli z-wave switches, and on these you can disable the relay. So the switch can still send out commands/scenes on the network but the relay is always on.

Then you would put in a relay unit in the electrical box of the lights or if you have enough room in with the switches. Then setup the switches to control their respective sets of lights.

Might even be a switch out there that lets you disconnect the relay from the buttons on the switch but still control the relay which would cut down on the device count.

This was a separate outage unrelated to CrowdStrike a few hours earlier that took down a couple of airlines as well.

A majority of the VMs in the Azure CentralUS datacenter went down due to some sort of backend storage issue.

Edit: I guess I should have read the article they do say CrowdStrike. They seem to be implying that they were one event when the cloud services outage was earlier and unrelated. I had heard about grounded flights during the first outage as well. So they likely are combining the two events here.

I would think most wifi jamming is just deauth attacks. It is much easier to just channel hop, enumerate clients, and send them deauthentication packets.

This way you don’t need a particularly powerful radio/antenna, any laptop/hacking tool with Wi-Fi is all you need. There are scripts out there that automate the whole thing, so almost no deep knowledge of wifi protocols are required.

WPA3 has protected management frames to protect against this but most IoT cameras probably don’t support WPA3 yet.