• RedGreenBlue@lemmy.zip
    link
    fedilink
    arrow-up
    25
    ·
    edit-2
    13 hours ago

    USB is intelligent. The device should draw as much current as it asks for. If the device is not detecting any host to do any data transfer with, then it is probably idling at lowest unit power load. I would bet it’s not bad for it in any way. As long as that power brick lives up to the standard.

  • RejZoR@lemmy.ml
    link
    fedilink
    English
    arrow-up
    45
    ·
    16 hours ago

    Actually that’s not as absurd as it seems. NAND memory starts corrupting data if it doesn’t get any current for few years. I’m not sure if just power on USB triggers it or does controller on device need to be specifically activated by OS detection. I guess controller goes on the moment it gets power.

    • lurch (he/him)@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      17
      ·
      edit-2
      14 hours ago

      In theory, just getting current does nothing. It has to be rewritten. It uses hot electron tunneling.

      However, I recently found an mp3-player I hadn’t used since longer than 2017 on the bottom of a drawer. It was stored without battery. I put an AAA battery in and it played the stored music just fine.

      • bacon_pdp@lemmy.world
        link
        fedilink
        arrow-up
        12
        ·
        13 hours ago

        Older lithography holds charge longer; the pursuit of more storage at cheaper prices results in engineering sacrifices to make it happen.

        • Cornelius_Wangenheim@lemmy.world
          link
          fedilink
          arrow-up
          4
          ·
          7 hours ago

          Older devices also stored fewer bits per well. It’s much easier for the data to get corrupted when the difference in voltage between two values is smaller.

    • BorgDrone@feddit.nl
      link
      fedilink
      arrow-up
      12
      ·
      edit-2
      10 hours ago

      Nothing at all.

      The power supply only puts 5V on the appropriate pins, just like a computer would. Since there is no computer, the drive will do nothing. Even if the power supply has USB-power delivery it won’t actually supply a higher voltage until the device asks for it, and this device won’t.

  • potatopotato@sh.itjust.works
    link
    fedilink
    arrow-up
    22
    ·
    16 hours ago

    So, technically flash storage is just electric charge stored in a cell and it does need periodic recharging as the cells leak over time (3+ years minimum). If the flash controller is capable of doing this automatically, then powering the drive like this may enable that to happen. I wouldn’t bet on it though.

  • phorq@lemmy.ml
    link
    fedilink
    arrow-up
    7
    ·
    16 hours ago

    Good advice, but I wouldn’t trust Anker with my data refuel after their Eufy scandal