It doesn’t even need to be that fancy. Basic ones will just react to reduced flow on the hot or cold side by reducing the other side proportionally to keep the temperature roughly the same.
That’s a thermostat and won’t do you any good if the plumbing is set up in such a way, that all outlets are connected in series. You need a parallel approach (manifold with large diameter branching off to all outlets).
Maybe you’ve just happened to use hardware that was installed a while ago? Or you’re in an area that’s more traditionalist. I suppose there could be many reasons. Those are arguably also a little more expensive, so that could also be a reason.
I’ve had to replace the entire mixing valve so that’s what I thought of. Too old for a cartridge or also so old the cartridge was frozen in place. A pain usually.
What sorcery is this “balancing valve” that I’ve never heard of or had the pleasure of experiencing!?!?!
It maintains the same temp, even when hot water temp or pressure is changing
I can’t speak for everyone but here’s what mine like like:
It doesn’t even need to be that fancy. Basic ones will just react to reduced flow on the hot or cold side by reducing the other side proportionally to keep the temperature roughly the same.
Ah, called a thermostatic valve here I think? Maybe?
The fuck?
This exist?
Did I live under the bottom of a well or something?
That would explain why your water’s so cold, at least
That’s a thermostat and won’t do you any good if the plumbing is set up in such a way, that all outlets are connected in series. You need a parallel approach (manifold with large diameter branching off to all outlets).
Those have been standard for a while now.
No. I’ve never used one in Europe but I know they exist here from advertising.
Maybe you’ve just happened to use hardware that was installed a while ago? Or you’re in an area that’s more traditionalist. I suppose there could be many reasons. Those are arguably also a little more expensive, so that could also be a reason.
Something that breaks after 10 years time.
…and that there was no planned access to for replacement.
They’re actually not hard to replace at all. Just look up “shower cartridge replacement” on YouTube.
I’ve had to replace the entire mixing valve so that’s what I thought of. Too old for a cartridge or also so old the cartridge was frozen in place. A pain usually.