2.2 pounds per kilogram. For a rough conversion just multiply or divide by two. For a more precise conversation do the same thing, then wiggle a decimal and do it again.
A yard is about 1.4 litres in my book, or 2.1/2 pints - imperial pints mind, not US ones.
I’m not ignoring away that 20% difference; it’s bad enough with all the fucking “pint to brim” glasses these days.
I usually just go with 1.5 because adding half/subtracting a third is way easier to do in my head, and I’m not worried about a ~10% error in casual conversation.
The only metric to imperial conversion I remember is kilometers to miles since it’s pretty close to the golden ratio.
Even if you don’t remember that the golden ratio is 1.6 and a bit, you can approximate it by using successive terms of the Fibonacci sequence.
1, 1, 2, 3, 5, 8, 13 …
So 8 miles is about 13km (actually 12.87)
2.2 pounds per kilogram. For a rough conversion just multiply or divide by two. For a more precise conversation do the same thing, then wiggle a decimal and do it again.
Its 2.54 cm to the inch. Its close to 2.5 and as an engineer in America I am stuck doing that conversion a lot
If it makes you feel any better, most pipe standards around the world are based on the American system, as well as bloody valve coefficients.
I am far too aware that 1" is 25.4 mm :(
And I’m in Australia. Grumble
This has blown my mind
Fucking Dan Brown in the comment section
Lmao your username is awesome
and your username is scary
You should use a rolling release distro and always update to the bleeding edge.
You will not regret using a rolling release distro and always updating to the bleeding edge.
It is not easier for me to sneak backdoors into your system when you are using a rolling release distro and are always updating to the bleeding edge.
🙂
Thank you, kind stranger on the internet!
You’re welcome, @[email protected] 💖
A meter is a Baker’s yard. 3 free inches!
Forma me it’s the yard. It’s so close to the meter its ridiculous. I just ignore the difference an treat as the same. One yard = 0.9144 meters
A yard is about 1.4 litres in my book, or 2.1/2 pints - imperial pints mind, not US ones. I’m not ignoring away that 20% difference; it’s bad enough with all the fucking “pint to brim” glasses these days.
Liters? Pints? How are you converting from distance to volume?
I usually just go with 1.5 because adding half/subtracting a third is way easier to do in my head, and I’m not worried about a ~10% error in casual conversation.
I just go with 1.6 because its still easy enough to do in your head.
Eg. 60mi = 60 + (60/2) + (60/10) = 96km